Debug Platform Port-Security - Cisco Catalyst Blade Switch 3130 Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands

debug platform port-security

Use the debug platform port-security privileged EXEC command to enable debugging of
platform-dependent port-security information. Use the no form of this command to disable debugging.
Syntax Description
add
aging
all
delete
errors
rpc
warnings
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug platform port-security command is the same as the no debug platform port-security
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
OL-13271-01
debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
no debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
Display secure address addition debug messages.
Display secure address aging debug messages.
Display all port-security debug messages.
Display secure address deletion debug messages.
Display port-security error debug messages.
Display remote procedure call (RPC) debug messages.
Display warning debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
debug platform port-security
B-53