Debug Platform Snmp - Cisco Catalyst Blade Switch 3130 Reference Manual
For dell command reference
Hide thumbs
Also See for Catalyst Blade Switch 3130:
- Software configuration manual (1354 pages) ,
- Hardware installation manual (84 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
Appendix B
Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
debug platform snmp
Use the debug platform snmp privileged EXEC command to enable debugging of the
platform-dependent Simple Network Management Protocol (SNMP) software. Use the no form of this
command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(40)EX1
Usage Guidelines
The undebug platform snmp command is the same as the no debug platform snmp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Command
show debugging
OL-13271-01
debug platform snmp
no debug platform snmp
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
debug platform snmp
B-57
Advertisement
Table of Contents
