Debug Platform Resource-Manager - Cisco Catalyst Blade Switch 3130 Reference Manual

debug platform resource-manager

debug platform resource-manager
Use the debug platform resource-manager privileged EXEC command to enable debugging of the
resource manager software. Use the no form of this command to disable debugging.
Syntax Description
all
dm
erd
errors
madmed
sd
stats
vld
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug platform resource-manager command is the same as the no debug platform
resource-manager command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
B-56
debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
no debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
Display all resource manager debug messages.
Display destination-map debug messages.
Display equal-cost-route descriptor-table debug messages.
Display error debug messages.
Display the MAC address descriptor table and multi-expansion descriptor table
debug messages.
Display the station descriptor table debug messages.
Display statistics debug messages.
Display the VLAN-list descriptor debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
OL-13271-01