Debug Ip Verify Source Packet - Cisco Catalyst Blade Switch 3130 Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands

debug ip verify source packet

Use the debug ip verify source packet privileged EXEC command to enable debugging of IP source
guard. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines
The undebug ip verify source packet command is the same as the no debug ip verify source packet
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
OL-13271-01
debug ip verify source packet
no debug ip verify source packet
Modification
This command was introduced.
Description
Displays information about the types of debugging that are
enabled.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
debug ip verify source packet
B-11