Ip Arp Inspection Validate - Cisco Catalyst Blade Switch 3130 Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands

ip arp inspection validate

Use the ip arp inspection validate global configuration command on the switch stack or on a standalone
switch to perform specific checks for dynamic Address Resolution Protocol (ARP) inspection. Use the
no form of this command to return to the default settings.
This command is available only if your switch is running the IP services feature set.
Syntax Description
src-mac
dst-mac
ip
allow-zeros
Defaults
No checks are performed.
Command Modes
Global configuration
Command History Release
12.2(40)EX1
Usage Guidelines
You must specify at least one of the keywords. Each command overrides the configuration of the
previous command; that is, if a command enables src-mac and dst-mac validations, and a second
command enables IP validation only, the src-mac and dst-mac validations are disabled as a result of the
second command.
OL-13271-01
ip arp inspection validate {[src-mac] [dst-mac] [ip [allow zeros] ]}
no ip arp inspection validate [src-mac] [dst-mac] [ip [allow zeros] ]
Compare the source MAC address in the Ethernet header against the sender MAC
address in the ARP body. This check is performed on both ARP requests and
responses.
When enabled, packets with different MAC addresses are classified as invalid and are
dropped.
Compare the destination MAC address in the Ethernet header against the target MAC
address in ARP body. This check is performed for ARP responses.
When enabled, packets with different MAC addresses are classified as invalid and are
dropped.
Compare the ARP body for invalid and unexpected IP addresses. Addresses include
0.0.0.0, 255.255.255.255, and all IP multicast addresses.
Sender IP addresses are compared in all ARP requests and responses. Target IP
addresses are checked only in ARP responses.
Modifies the IP validation test so that ARPs with a sender address of 0.0.0.0 (ARP
probes) are not denied.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
ip arp inspection validate
2-157