Cisco Catalyst Blade Switch 3130 Reference Manual page 890

debug platform tcam
Usage Guidelines
The undebug platform tcam command is the same as the no debug platform tcam command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
B-64
Appendix B
Description
Displays information about the types of debugging that are enabled.
Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
OL-13271-01