Cisco Catalyst Blade Switch 3130 Reference Manual page 514
For dell command reference
Hide thumbs
Also See for Catalyst Blade Switch 3130:
- Software configuration manual (1354 pages) ,
- Hardware installation manual (84 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
show ip verify source
•
•
This is an example of output on an interface on which IP source guard is disabled:
Switch> show ip verify source gigabitethernet1/0/6
IP source guard is not configured on the interface gi1/0/6.
Related Commands
Command
ip verify source
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
2-486
On the Gigabit Ethernet 1/0/4 interface, IP source guard with source IP and MAC address filtering
is enabled, and static IP source bindings are configured on VLANs 10 and 11. For VLANs 12 to 20,
the default port ACL is applied on the interface for the VLANs on which IP source guard is not
configured.
On the Gigabit Ethernet 1/0/5 interface, IP source guard with source IP and MAC address filtering
is enabled and configured with a static IP binding, but port security is disabled. The switch cannot
filter source MAC addresses.
Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
Description
Enables IP source guard on an interface.
OL-13271-01
Advertisement
Table of Contents
