Ip Admission - Cisco Catalyst Blade Switch 3130 Reference Manual

ip admission

ip admission
Use the ip admission interface configuration command to enable web authentication. You can also use
this command in fallback-profile mode. Use the no form of this command to disable web authentication.
Syntax Description
rule
Command Modes Global configuration
Command History Release
12.2(40)EX1
Usage Guidelines The ip admission command applies a web authentication rule to a switch port.
Examples
This example shows how to apply a web authentication rule to a switchport:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip admission rule1
This example shows how to apply a web authentication rule to a fallback profile for use on an
IEEE 802.1x enabled switch port.
Switch# configure terminal
Switch(config)# fallback profile profile1
Switch(config)# ip admission name rule1
Switch(config)# end
Related Commands Command
dot1x fallback
fallback profile
ip admission name
proxy http
show ip admission
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
2-146
ip admission rule
no ip admission
Apply an IP admission rule to the interface.
Modification
This command was introduced.
Description
Configure a port to use web authentication as a fallback method for clients
that do not support IEEE 802.1x authentication.
Enable web authentication on a port
Enable web authentication globally on a switch
Displays information about NAC cached entries or the NAC configuration.
For more information, see the Network Admission Control Software
Configuration Guide on Cisco.com.
Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
OL-13271-01