Debug Platform Cli-Redirection Main - Cisco Catalyst Blade Switch 3130 Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands

debug platform cli-redirection main

Use the debug platform cli-redirection main privileged EXEC command to enable debugging of the
main (important) command-line interface (CLI) redirection events. Use the no form of this command to
disable debugging.
This command is supported only on stacking-capable switches.
Note
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines
The undebug platform cli-redirection main command is the same as the no debug platform
cli-redirection main command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
OL-13271-01
debug platform cli-redirection main
no debug platform cli-redirection main
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
debug platform cli-redirection main
B-27