Cisco Catalyst Blade Switch 3130 Reference Manual page 475

Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
transceiver
[detail |
properties]
trunk
| begin
| exclude
| include
expression
Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
Note
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
•
•
•
•
•
•
•
OL-13271-01
(Optional) Display the physical properties of a coarse wavelength-division
multiplexer (CWDM) or dense wavelength-division multiplexer (DWDM) small
form-factor (SFP) module interface. The keywords have these meanings:
detail—(Optional) Display calibration properties, including high and low
•
numbers and any alarm information.
properties—(Optional) Display speed, duplex, and inline power settings on
•
an interface.
Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
On stacking-capable switches, use the show interface capabilities module number command to
display the capabilities of all interfaces on that switch in the stack. If there is no switch with that
module number in the stack, there is no output.
On nonstacking-capable switches, use the show interface capabilities module 1 command to
display the capabilities of all interfaces on the switch. Any other number is invalid.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
On stacking-capable switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces in the stack.
On nonstacking-capable switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces on the switch.
On stacking-capable switches, use the show interface switchport module number command to
display the switch port characteristics of all interfaces on that switch in the stack. If there is no
switch with that module number in the stack, there is no output.
On nonstacking-capable switches, use the show interface switchport module 1 to display the
switch port characteristics of all interfaces on the switch. Any other number is invalid.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
show interfaces
2-447