Mac Access-Group - Cisco Catalyst Blade Switch 3130 Reference Manual

For dell command reference
Hide thumbs Also See for Catalyst Blade Switch 3130:
Table of Contents

Advertisement

Chapter 2
Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands

mac access-group

Use the mac access-group interface configuration command on the switch stack or on a standalone
switch to apply a MAC access control list (ACL) to a Layer 2 interface. Use the no form of this command
to remove all MAC ACLs or the specified MAC ACL from the interface. You create the MAC ACL by
using the mac access-list extended global configuration command.
Syntax Description
name
in
Defaults
No MAC ACL is applied to the interface.
Command Modes
Interface configuration (Layer 2 interfaces only)
Command History
Release
12.2(40)EX1
Usage Guidelines
You can apply MAC ACLs only to ingress Layer 2 interfaces. You cannot apply MAC ACLs to Layer 3
interfaces.
On Layer 2 interfaces, you can filter IP traffic by using IP access lists and non-IP traffic by using MAC
access lists. You can filter both IP and non-IP traffic on the same Layer 2 interface by applying both an
IP ACL and a MAC ACL to the interface. You can apply no more than one IP access list and one MAC
access list to the same Layer 2 interface.
If a MAC ACL is already configured on a Layer 2 interface and you apply a new MAC ACL to the
interface, the new ACL replaces the previously configured one.
If you apply an ACL to a Layer 2 interface on a switch, and the switch has an input Layer 3 ACL or a
VLAN map applied to a VLAN that the interface is a member of, the ACL applied to the Layer 2
interface takes precedence.
When an inbound packet is received on an interface with a MAC ACL applied, the switch checks the
match conditions in the ACL. If the conditions are matched, the switch forwards or drops the packet,
according to the ACL.
If the specified ACL does not exist, the switch forwards all packets.
For more information about configuring MAC extended ACLs, see the "Configuring Network Security
with ACLs" chapter in the software configuration guide for this release.
OL-13271-01
mac access-group {name} in
no mac access-group {name}
Specify a named MAC access list.
Specify that the ACL is applied in the ingress direction. Outbound ACLs are not
supported on Layer 2 interfaces.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
mac access-group
2-241

Advertisement

Table of Contents
loading

Table of Contents