Cisco Catalyst Blade Switch 3130 Reference Manual page 856

debug platform cpu-queues
Usage Guidelines
The undebug platform cpu-queues command is the same as the no debug platform cpu-queues
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
B-30
Appendix B
Description
Displays information about the types of debugging that are enabled.
Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
OL-13271-01