Remote Node Filter; Figure 16 Menu 11.2.4: Dial Backup Remote Node Filter - Nortel 222 User Manual

Remote node filter

Move the cursor to the field Edit Filter Sets in menu 11.2, and then press
[SPACE BAR] to set the value to Yes. Press [ENTER] to open
Remote Node Filter.
Use menu 11.2.4 to specify the filter sets to apply to the incoming and outgoing
traffic between this remote node and the Business Secure Router to prevent
certain packets from triggering calls. You can specify up to four filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces
are accepted in this field. Refer to
for more information about defining the filters.

Figure 16 Menu 11.2.4: dial backup remote node filter

Menu 11.2.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Nortel Business Secure Router 222 Configuration — Advanced
Chapter 3 WAN and Dial Backup Setup 69
Chapter 11, "Filter configuration," on page 135
Menu 11.2.4 -