Led Indications During The Download Process; Configuration File Download/Upload Screen - Nortel 1000ASE-XD Using Manual

Table 39 Software Download screen fields (continued)
Field Description
TFTP Server IP The IP address of your TFTP load host.
Address
Default Value
Range
Start TFTP Load Specifies whether to start the download of the switch software image (default is No).
of New Image
Use the spacebar to toggle the selection to Yes.
Press [Enter] to initiate the software download process.
NOTE: The software download process can take up to 60 seconds to complete (or more
if the load host path is congested or there is a high volume of network traffic).
To ensure that the download process is not interrupted, do not power down the switch for
approximately 10 minutes.
Default Value
Range

LED Indications during the download process

The software download process automatically completes without user
intervention. The process erases the contents of flash memory and replaces it with
a new software image. Be careful not to interrupt the download process until after
it runs to completion (the process can take up to 10 minutes, depending on
network conditions).

Configuration File Download/Upload screen

The Configuration File Download/Upload screen
your switch/stack configuration parameters on a TFTP server.
0.0.0.0 (no IP address assigned)
Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, separated by a decimal point
No
Yes, No
Note: If problems occur during the software download process, the
Software Download screen displays error codes that define the problem.
The error codes are described in
173.
Chapter 3 Using the console interface
Chapter 4, "Troubleshooting," on page
(Figure 77) allows you to store
Using the BayStack 420 10/100/1000 Switch
169