Programmable Parameters; Speed Settings - Otto Bock A200 Service Instructions Manual

8.4 Programmable Parameters
The following programmable parameters represent a selection. Information on other program-
mings is contained in the document "VR2 SERIES WHEELCHAIR CONTROL SYSTEM; OP-
ERATION, INSTALLATION & PROGRAMMING".

8.4.1 Speed Settings

Parameter Setting range
Acceleration Single steps
from 0 to 100
Deceleration Single steps
from 0 to 100
Turn Acceleration Single steps
from 0 to 100
Turn Deceleration Single steps
from 0 to 100
Forward Speed Single steps
from 0 to 100
Reverse Speed Single steps
from 0 to 100
Turning Speed Single steps
from 0 to 100
54
Description
Adjusts the value for forward and reverse acceleration of the
wheelchair.
A higher value gives faster acceleration. This programmed val-
ue of acceleration occurs when speed setting 5 is selected. Its
value at other settings depends on the value of the Minimum
Acceleration parameter.
Adjusts the value for forward and reverse deceleration (or brak-
ing) of the wheelchair.
A higher value gives faster deceleration. This programmed val-
ue of deceleration occurs when speed setting 5 is selected. Its
value at other settings depends on the value of the Minimum
Deceleration parameter.
Adjusts the value for turning acceleration of the wheelchair.
A higher value gives faster acceleration. This programmed val-
ue of acceleration occurs when speed setting 5 is selected. Its
value at other settings depends on the value of the Minimum
Turn Acceleration parameter.
Adjusts the value for turning deceleration (or braking) of the
wheelchair.
A higher value gives faster deceleration. This programmed val-
ue of deceleration occurs when speed setting 5 is selected. Its
value at other settings depends on the value of the Minimum
Turn Deceleration parameter.
Adjusts the minimum and maximum values for forward speed
of the wheelchair.
A higher value gives a faster speed. The minimum value occurs
when the speed setting 1 is selected, and the maximum value
occurs at speed setting 5.
Adjusts the minimum and maximum values for reverse speed
of the wheelchair.
A higher value gives a faster speed. The minimum value occurs
at speed setting 1, and the maximum value occurs at speed
setting 5.
Adjusts the minimum and maximum values for the turning speed
of the wheelchair.
A higher value gives a faster speed. If Drive Profile 0 is selected
then the minimum value occurs when speed setting 1 is selected,
and the maximum value occurs when speed setting 5 is selected.