Controller Replacement - Otto Bock A200 Service Instructions Manual

Steps:
6. Disconnect the old main battery cable from the contact strip (Fig. 6).
7. Remove the contact strip and replace, if necessary (Fig. 8).
Properly reassemble all components upon completion of the work.
fig. 8 Contact strip replacement
6.3 Controller Replacement
INfORMATION
Ensure correct polarity is used when connecting the cables.
Preparation:
❒ Separate the frame from the drive unit sustainer (see instructions for use 647G545, Sec-
tion 5.2).
❒ Remove the battery packs (see Section 6.2.2).
Tools:
❒ Allen wrench, 3 mm
Steps:
1. Remove the protective cover (Fig. 9, item A).
2. Remove all connectors on the controller.
3. Loosen the two Allen head screws, remove the controller and replace if required.
Properly reassemble all components upon completion of the work.
18