Side Panels; Adapting / Replacing The Side Panels - Otto Bock A200 Service Instructions Manual

fig. 9 Removing the protective cover / connectors on the controller
1 Control device connector
2 Motor 1 connector
3 Motor 2 connector
4 Battery connector
6.4 Side Panels
INfORMATION
For adjusting the side panel attachment devices (width setting), refer to Section 6.8.7.

6.4.1 Adapting / Replacing the Side Panels

A side panel attachment device is located on the left and right sides of the seat frame. The side
panels with arm rests are inserted into these attachment devices. The height and position of the
side panels can be individually adapted to the arm length of the wheelchair user.
Tools:
❒ Allen wrench, 2 mm
a) Adapting to the forearm length
Side panel without control panel:
Steps:
1. Loosen the two Allen head screws (Fig. 10, item A).
2. Change the position of the arm rests by moving them forward or backward, or remove and
replace them if required.
Side panel with control panel:
Steps:
1. Loosen the sliding nuts in the C-profile (Fig. 10, item B).
2. Adjust / replace the arm rest and tighten the sliding nuts.
A 1 2 4 3
A
19