Steps:
1. Jack up the drive wheels.
2. Loosen all four Allen head screws, remove the wheel and replace if required.
Properly reassemble all components upon completion of the work.
INfORMATION
When installing the wheel, tighten all four Allen head screws to a torque of 25 Nm (18.4 ft.lbf/221 in.lbf).
fig. 21
Removing the drive wheel
6.6.4 Replacing the Wheel flange
Preparation:
❒ Remove the wheel.
Tools:
❒ Socket, 18 mm
❒ Puller
Steps:
1. Loosen the wheel flange screw (Fig. 22).
2. Use the puller to remove the wheel flange and replace it required (Fig. 23).
Properly reassemble all components upon completion of the work.
INfORMATION
When installing the wheel, tighten all four Allen head screws to a torque of 55 Nm (40.6 ft.lbf/487 in.lbf).
27