Otto Bock A200 Service Instructions Manual page 23

b) Adapting to thigh length (adjusting the footrest receiver)
This setting is changed on the footrest holders that are mounted to the seat frame.
Steps:
1. Pull the footrest lock lever back and pull the footrest up and out (see Figure 14).
2. On either side, loosen the three Allen head screws on the seat frame (Fig. 16, item A).
3. Adjust the footrest receiver to a different length (Fig. 16, item B).
Properly reassemble all components upon completion of the work.
fig. 16 Adapting the footrest to the thigh length
c) Installing elevating footrests with calf and knee pads
Tools:
❒ Allen wrench, 3 mm
❒ Ring or open-end wrench, 10 mm
Steps:
1. Remove and replace the standard footrests.
2. Remove the standard footrest receiver (see paragraph b).
3. Install the footrest receiver for elevating footrests.
4. Insert the elevating footrests into the footrest receiver.
d) Replacing the knee pad
Steps:
1. Remove the footrest.
2. Loosen the Allen head screw.
3. Remove the knee pad or replace if required.
Properly reassemble all components upon completion of the work.
B B
A A A A A A
23