Resolving Camera Issues
Problem
Solution
Solution
Problem
Solution
Solution
Solution
RADVISION | Administrator Guide for SCOPIA XT4000 Series Version 3.0
Cannot see the camera's output after setting up.
Press
on the XT Remote Control Unit repeatedly to switch between the different video
sources.
Ensure the camera is correctly connected to the system.
I can see the camera's output, but I cannot move the camera.
Press
on the XT Remote Control Unit repeatedly to switch between the different video
sources.
Ensure the camera is correctly connected to the system.
Make sure the Moving setting is enabled:
1.
Access the SCOPIA XT Series web interface.
2.
In the Administrator settings tab, select I/O Connections > Cameras > General > HD1.
Figure 3-6
3.
Make sure that the Moving field is set to Yes.
Enabling the Moving setting
Troubleshooting | 31