Direct Transmission; Direct Transmission As Default Setting - Toshiba DP80F Operator's Manual

Direct Transmission

Direct Transmission is used if
there is not enough residual
memory or when a large num-
ber of document pages are to
be sent, etc.
1
This mode is also useful if the
operator wishes to visually con-
firm the actual transmission of
the document to the remote par- This procedure will discuss Di-
ty. rect Transmission when se-
lected as the default setting or
The documents will remain in
when Residual Memory has
the ADF and be transmitted one
been depleted.
by one.
Load the document face down
in the Document Support (see
page 82).
Adjust the resolution and con-
trast if desired (see pages 83
and 84).
Example of screen displayed
when Residual Memory has
been depleted:

Direct Transmission as Default Setting

2
Load the Document
Dial the facsimile number of the
remote party using any of the
four dialing methods.
•
•
•
•
MAY-17 09:43 AM 100%
• Press
AUTO RECEIVE
ror occurs.
Example of screen displayed
while a number is entered using
Keypad Dialing:
MAY-17 09:43 AM 0%
TEL NUMBER =(MAX128)
AUTO RECEIVE
0559761234
3
Dial the Facsimile Start Dialing
Number
Once the facsimile number is
entered, the dialing starts.
One Touch Key Dialing
DIALING
... See page 89
Abbreviated Dialing
... See page 90
If the destination facsimile is
Alphabet Dialing
busy, the screen below is dis-
... See page 91
played.
Keypad Dialing
... See page 92
WAITING TO REDIAL
if a dialing er-
If the redial procedure is com-
pleted without a success, the
screen below is displayed and
printed the Transmission Re-
port.
MAY-17 09:43 AM 100%
PRINTING LIST
MAY-17 09:43 AM 100%
LINE BUSY
4
Line Connection to
the Remote Party
Once connected to the destina-
tion facsimile, the screen below
is displayed.
COMMUNICATING
0559761234
+81 559 761234
AUTO RECEIVE
After printing
95