Toshiba DP80F Operator's Manual page 229

When the Recorded Image is not Clear... - continued
Recording Unit Cleaning Procedure - continued
5
Wipe the Bottom 6
Side of Paper Guide
68
Install the Drum Unit into the ma-
Wipe the bottom side of Paper
chine, aligning the guides of the
Guide with a dry cloth.
Unit with the grooves inside the
If the surfaces require moisture
machine.
to remove the dirt, use a cloth
Color coordinated "1" labels have
slightly dampened with water to
been affixed to the Drum Unit
remove the dirt, followed by a
and to the inside of the machine.
dry cloth.
Install the Drum Unit by aligning
these labels.
Make sure the Drum Unit is in-
serted inside the machine as far
as it will go.
IMPORTANT:
•
•
7
Install the Toner Cartridge
Install the Drum Unit
45
40
Holding onto the Toner Car-
tridge's handle, lower it into the
machine. Make sure that the
four pins (two on each side) fit
into the grooves inside the ma-
chine.
Color coordinated "2" labels
have been affixed to the Toner
Cartridge and to the inside of
the machine. Install the Toner
Cartridge by aligning these la-
bels.
As the Toner Cartridge is low-
Never touch the photocon-
ered into the machine its handle
ductive drum (the green sur-
will rotate first to the rear of the
face) of the Drum Unit. If the
machine and then to the front.
surface is scarred or
scratched, it will cause print
The cartridge will click into place
quality problems.
when it is completely installed.
Do not expose the photocon-
ductive drum of the Drum Unit
to light for more than 3 min-
utes. If the Drum Unit is to be
left anywhere outside the fac-
simile, be certain to cover it
with cloth, paper, etc.
2 2
2 2
41
42
8
Close the Top Cover
43
Press down on the Top Cover
until a "Click" is heard to ensure
the latches engage.
Verify the display has returned
to the Standby Mode.
227