Scan Resolution Setting - Toshiba DP80F Operator's Manual

Scan Resolution Setting

The scan resolution can be set
to one of the following five
modes based on the type of im-
age you are scanning.
The scan resolution is normally
set to the default setting. When
you change the resolution, the
facsimile will return to the de-
fault setting after each transac-
tion. To change the default reso-
lution setting, see page 85.
STANDARD
For sending normal text and
graphics.
FINE
For sending normal text and
graphics with extra clarity.
U-FINE (Ultra-Fine)
For sending fine text and
graphics with extra clarity.
FINE HALFTONE
For detailed photos or docu-
ments with colors or shading.
U-FINE HALFTONE
(Ultra-Fine Halftone)
For very detailed photos or
*
documents with colors or
shading.
Press until the required resolution mode is
indicated by the appropriate LED.
(
The mode changes as follows:
FINE
Standard Mode (when all the lamps are extinguished)
U-FINE
HALFTONE
FINE
Fine Mode
U-FINE
HALFTONE
FINE
Ultra-Fine Mode
U-FINE
HALFTONE
FINE
Fine Halftone Mode
U-FINE
HALFTONE
FINE
Ultra-Fine Halftone Mode
U-FINE
HALFTONE
When Ultra-Fine is selected, the DF80F/DP85F will scan all
documents at 406 dots/inch horizontal x 391 lines/inch vertical.
Depending on the capabilities of the remote facsimile receiving
this document, the document may be transmitted by the DF80F/
DP85F at Ultra-Fine resolution (406 dots/inch horizontal x 391
lines/inch vertical) or it may be transmitted at Super Fine (203
dots/inch horizontal x 391 lines/inch vertical).
: illuminated
)
: extinguished
Each corresponding
lamp is illuminated.
83