Direct Transmission; Direct Transmission As Default Setting - Toshiba ESTUDIO170F Operation Manual

Direct Transmission

Direct Transmission is used if
there is not enough residual
memory or when a large num-
ber of document pages are to
be sent, etc.
This mode is also useful if the
operator wishes to visually
confirm the actual transmission
of the document to the remote
party.
The documents will remain in
the ADF and be transmitted
one by one.
All transmissions will be sent
via Direct Transmission if the
Memory Transmission function
is set default off (See page
142).
Direct Transmission as a Default Setting
1
Load the Document
This procedure will discuss Di-
rect Transmission when se-
lected as the default setting or
when Residual Memory has
been depleted.
Load the document face down
in the Document Support (see
page 82).
Adjust the resolution and con-
trast if desired (see pages 83
and 84).
JAN-31 09:43 AM 100%
AUTO RECEIVE
Example of screen displayed
when Residual Memory has
been depleted:
JAN-31 09:43 AM 0%
AUTO RECEIVE
2
Dial the Facsimile
Number
Dial the facsimile number of
the remote party using any of
the four dialing methods.
• One Touch Key Dialing
... See page 89
• Abbreviated Dialing
... See page 90
• Alphabet Dialing
... See page 91
• Keypad Dialing
... See page 92
STOP
• Press if a dialing er-
ror occurs.
Example of screen displayed
while a number is entered us-
ing Keypad Dialing:
TEL NUMBER =(MAX128)
0559761234
3
Start Dialing
Once the facsimile number is
entered, the dialing starts.
DIALING
0559761234
If the destination facsimile is
busy, the screen below is dis-
played.
WAITING TO REDIAL
AUTO RECEIVE
If the redial procedure is com-
pleted without a success, the
screen below is displayed and
printed the Transmission Re-
port.
JAN-31 09:43 AM 100%
PRINTING LIST
After printing
JAN-31 09:43 AM 100%
LINE BUSY
4
Line Connection to
the Remote Party
Once connected to the desti-
nation facsimile, the screen
below is displayed.
COMMUNICATING
+81 559 761234
95