Toshiba DP80F Operator's Manual page 34

Drum Unit Replacement - continued
3 4
Install the New Drum
Unit
45 40
Install the new Drum Unit into Holding
the machine, aligning the guides Cartridge's handle, lower it into
of the Unit with the grooves in- the machine. Make sure that the
side the machine. four pins (two on each side) fit
Color coordinated "1" labels into the grooves inside the ma-
have been affixed to the Drum
chine.
Unit and to the inside of the ma- Color coordinated "2" labels
chine. Install the Drum Unit by have been affixed to the Toner
aligning these labels. Cartridge and to the inside of
the machine. Install the Toner
Make sure the Drum Unit is in-
Cartridge by aligning these la-
serted inside the machine as far
bels.
as it will go.
As the Toner Cartridge is low-
IMPORTANT:
ered
• Never touch the photocon-
handle will rotate first to the rear
ductive drum (the green sur-
of the machine and then to the
face) of the Drum Unit. If the
front.
surface is scarred or
The cartridge will click into place
scratched, it will cause print
when it is completely installed.
quality problems.
• Do not expose the photocon-
ductive drum of the Drum
Unit to light for more than 3
minutes. If the Drum Unit is
to be left anywhere outside
the facsimile, be certain to
cover it with cloth, paper,
etc.
32
Install the Toner Cartridge
2 2
2 2
41
onto the Toner
42
into the machine, its
5 6
Close the Top Cover
Perform the following procedure
to reset the Drum Unit counter
after you replace the Drum Unit.
Press:
43
Press down on the Top Cover
until a "Click" is heard to ensure
the latches engage.
Reset the Drum
Counter
+
+
+
+
RESET DRUM COUNT
2.NO
1.YES