Enabling Or Disabling Send After Scan Temporarily - Toshiba DP80F Operator's Manual

Enabling or Disabling Send after Scan Temporarily

If the Send After Scan Mode
1
Default Setting is set to "OFF",
this feature allows you enable
the Send After Scan mode for a
single transmission. Once that
Load the document face down
transmission is complete, the
in the Document Support (see
default status is regained.
page 82).
If you enable Send after Scan,
Adjust the resolution and con-
you will be given the opportunity
trast if desired (see pages 83
to select "SEND SCANNED
and 84).
PAGES" or "CANCEL SEND-
ING."
Select "SEND SCANNED PAG-
ES" if you want the pages
scanned to memory (prior to the
Memory Full) to be transmitted.
Select "CANCEL SENDING" if
you want to cancel that trans-
mission and try again later when
more memory is available or
use a Direct TX operation.
2
Load the Document Display the SEND
AFTER SCAN Menu
Press:
MAY-17 09:43 AM 100%
AUTO RECEIVE
SEND AFTER SCAN
1.ON
2.OFF
3
Select the Send
After Scan Option
Select the desired Send After
Scan Option.
To enable Send After Scan,
+
press:
+
UPON MEMORY FULL
2.SEND SCANNED PAGES
+
1.CANCEL SENDING
Go to Step 4.
+
To disable Send After Scan,
press:
The following is displayed for 2
seconds.
COMPLETED
Go to Step 5.
4
Select the Memory
Full Option
Select the desired Memory Full
Option.
To cancel the pages that have
been scanned, press:
To send the pages that have
been scanned, press:
The following screen is dis-
played. You may dial the remote
facsimile for your communica-
tion job. The display will return
to the Standby Mode in about
60 seconds if no keys are
pressed.
MAY-17 09:43 AM 100%
ENTER TEL NUMBER
175