Main Messages And Their Remedies - Konica Minolta bizhub 250 User Manual

5
5.8

Main messages and their remedies

Message
Original left on glass.
Original size cannot be detected.
Select paper size.
This mode cannot be set with XXX.
The Exit Tray has reached its max-
imum capacity. Please remove all
copies from the tray as indicated
by the arrow(s).
Input User Name and Password to
login.
Input Account Name and Pass-
word to login.
Account has reached its maximum
copy allowance. Please call your
administrator
Properly close the section(s) indi-
cated by the arrow(s)
Install the imaging Unit
Replenish paper.
5-32
Possible cause
The document was left
on the original glass.
À The document is not
positioned correctly.
Á A document with a
non-standard size or with
a size too small to be de-
tected is loaded.
Functions that cannot be
used together are select-
ed.
Since the maximum
amount of copies for the
indicated finisher output
tray has been exceeded,
the machine is unable to
make copies.
User authentication set-
tings have been speci-
fied. Copies cannot be
made unless a user name
and its correct password
are entered.
Account track settings
have been specified.
Copies cannot be made
unless an account name
and its correct password
are entered.
The limit on the number
of pages that can be
printed has been
reached.
Since a machine door or
cover is open or an op-
tion is not installed cor-
rectly, the machine is
unable to make copies.
The imaging unit is not in-
stalled correctly.
The indicated tray has
run out of paper.
Troubleshooting
Remedy
Remove the document from
the original glass.
À Position the document cor-
rectly.
Á Select the correct paper
size.
Make copies using only one of
the functions.
Remove all copies from the in-
dicated tray.
Type in your user name and
password. (See "Using the
machine with machine au-
thentication" on page 2-33.)
Type in your account name
and password. (See "Limiting
user access with account
track" on page 2-39.)
Contact your administrator.
Make sure that all doors and
covers are closed and that all
options are installed correctly.
Reinstall the imaging unit or
parts, or contact your techni-
cal representative.
Load paper into the indicated
tray. For details on loading pa-
per into the paper trays, refer
to "Loading paper into the 1st
or 2nd tray" on page 2-42,
"Loading paper into the LCT"
on page 2-44, and "Loading
paper into the bypass tray" on
page 2-46.
250/350