Adjusting The Fuser Unit Height (Adjusting Lateral Squareness) - Kyocera KM-2035 Service Manual

(8) Adjusting the fuser unit height (adjusting lateral squareness)

Follow the procedure below if the drum is not parallel to the fuser unit and therefore paper is not fed straight to the fuser
section and the trailing edge of image on either the front or rear side becomes longer.
Procedure
1. Remove the front left cover 1 and 2 (see
page 1-5-28).
2. Remove the screw and then remove the
stopper.
3. Loosen the screw holding the fuser unit.
4. In the case of copy example 1 (the trailing
edge of image of the machine rear side
becomes longer): Place the fuser unit on the
third step from the bottom of the spacer to
adjust the spacer position (height adjust-
ment of +0.5 mm).
In the case of copy example 2 (the trailing
edge of image of the machine front side
becomes longer): Place the fuser unit on the
first step from the bottom of the spacer to
adjust the spacer position (height adjust-
ment of -0.5 mm).
Height adjustment: 0 mm
(Second step from the bottom)
Fuser unit
Spacer
Stopper
5. Retighten the screw holding the fuser unit
and refit the stopper.
6. Refit all the removed parts.
Height adjustment: +0.5 mm
(Third step from the bottom)
[Cross section viewing from the right side of the machine]
Figure 1-5-74
Screw
Spacer
Figure 1-5-72
Original Copy
example 1
Figure 1-5-73
Height adjustment: -0.5 mm
(First step from the bottom)
2HA/2HB
Stopper
Copy
example 2
1-5-35