Detaching And Refitting The Fuser Heater M And S - Kyocera KM-2035 Service Manual

(3) Detaching and refitting the fuser heater M and S

Follow the procedure below to replace the fuser heater M and S.
Procedure
1. Remove the fuser unit and separate the
fuser right unit and left unit (see pages 1-5-
28, 30).
2. Remove the two screws holding each of the
fuser heater M and S on the front and rear of
the fuser left unit.
3. Pull out the fuser heater M and S from the
fuser left unit.
4. Replace the fuser heater M and S, and refit
all the removed parts.
Fuser heater S
Fuser heater M
Figure 1-5-65
Fuser heater S
Fuser heater M
Fuser heater S
Figure 1-5-66
2HA/2HB
Fuser heater M
1-5-31