Kyocera KM-2035 Service Manual page 49

Maintenance
item No.
Adjusting the scanner input properties
U060
Description
Adjusts the image scanning density.
Purpose
Used when the entire image appears too dark or light.
Method
Press the start key.
Setting
1. Change the setting using the zoom +/- keys.
Description
Image scanning density
Increasing the setting makes the density lower, and decreasing it makes the density higher.
2. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, test copying from an original is available.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
Caution
The following settings are also reset to the initial values by performing this maintenance item:
Exposure density gradient set in maintenance mode (U093)
Exposure set in the copy default item of the copier management mode
Turning the exposure lamp on
U061
Description
Turns the exposure lamp on.
Purpose
To check the exposure lamp.
Method
1. Press the start key. "on" appears.
2. Press the start key. The exposure lamp lights.
3. To turn the exposure lamp off, press the stop/clear key.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
Adjusting the shading position
U063
Description
Changes the shading position.
Purpose
Used when white lines continue to appear longitudinally on the image after the shading plate is cleaned. This
is due to flaws or stains inside the shading plate. To prevent this problem, the shading position should be
changed so that shading is possible without being affected by the flaws or stains.
Method
1. Press the start key.
2. Change the setting using the zoom +/- keys.
Description
Shading position
Increasing the setting moves the shading position toward the machine left, and decreasing it moves the
position toward the machine right.
3. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, test copying from an original is available.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
Description
Setting range
0 to 23
Setting range Initial setting
-5 to 5 0
2HA/2HB
Initial setting
12
Change in value per step
0.17 mm
1-3-17