Kyocera KM-2035 Service Manual page 142

2HA/2HB
4. Insert the locating ball on each of the scan-
ner wires into the hole in the respective
scanner wire drum and wind the scanner
wire three turns inward and four turns out-
ward.
With the locating ball as the reference point,
wind the shorter end of each of the wires
outward.
5. Secure the scanner wires using the scanner
wire stoppers.
Four turns outward
6. Refit the scanner wire drum shaft to the
scanner unit.
7. Insert the two frame securing tools into the
positioning holes at the front and rear of the
scanner unit to pin the mirror 2 frame in
position.
1-5-16
Scanner wire stoppers
Three turns inward
Locating ball
Scanner wire drum
Figure 1-5-34
Three turns inward
Four turns outward
Frame securing tool
Figure 1-5-35
Frame securing tool
Mirror 2 frame