Oce OP30C Operation Manual page 69

10. Windows KX Driver
10-7 Output Tab
Output to:
Specifies the location of ejection of printed copies.
Selection is possible when the optional output devices are installed.
[Printer Default] ................................... Copies will be ejected into the location that is selected in the printer as the place where the printed
[Inner Tray] ........................................... Copies will be ejected onto the Inner tray.
[Side Tray (Face-Up)] ........................... Copies will be ejected onto the side tray.
[Main Tray] ............................................ Copies will be ejected into the lower tray of the optional Finisher.
[Sub Tray] ............................................. Copies will be ejected into the upper tray of the optional Finisher.
* If you designate a setting other than "Main Tray" or "Sub Tray" as the location of ejection, it is necessary to first select "Document
Finisher" under "Device Options" on page 10-16.
Copies
Specifies the number of prints to be made. Select between 1 and 999 copies by clicking on the arrows at the right of the field or by typing
the desired number directly into the field. The factory default setting is "1".
Collate
When you are printing more than one copy of one or more pages, it is possible to sort the printed copy sets.
* When you want to make multiple copy sets, put a check mark in checkbox next to "RAM Disk" under the "Device Settings" Tab and set
the memory size for the RAM disk. (Be sure to enter the same setting as that made in the printer.)
If, however, the optional hard disk is installed, put a check mark in checkbox next to "Hard Disk".
* If you select to turn on the "Staple" setting (see page 10-10), it is necessary to select "Collate" here.
Example: If the "Collate" option is selected, it is possible to print out 2 sets of the same copies.
paper will be ejected.
10-9