Oce OP30C Operation Manual page 25

2. Printer Settings
2-4 Network (TCP/IP) settings
When this machine is to be used as a network printer, it is necessary to set the corresponding IP address for the printer.
Notes
• The IP address that should be registered here will differ depending upon your network environment. Check with your network administrator
BEFORE performing this setting.
• If you are using a DHCP server to automatically configure the IP address, this setting will not be necessary because DHCP server configu-
ration is already enabled as the factory default setting.
Press the Printer key. The machine will switch to the printer mode.
1
Use the "M" and "N" cursor keys to select "MENU" and then press the Enter key.
2
Use the "M" and "N" cursor keys to select "Interface" and then press the Enter key.
3
4 Use the "M" and "N" cursor keys to select "Option 1" and then press the Enter key.
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification
2-19