Oce OP30C Operation Manual page 14

2. Printer Settings
Item No.
Interface selection
11
Displays the interface that is currently
selected. The arrow (>) will indicate the
currently selected interface. The printer will
automatically switch to the appropriate
interface for printing.
Parallel TX/RX mode
12
Sets the transmission and reception mode
when the printer is connected to your
computer with a parallel interface.
Baud rate
13
Sets the baud rate for the serial interface.
Data bits
14
Sets the data bits for the serial interface.
Stop bit
15
Sets the stop bit for the serial interface.
Parity
16
Sets the parity for the serial interface.
Protocol
17
Sets the protocol for the serial interface.
Barcode mode
18
Set to "ON" when the optional Barcode
Reader is installed.
Item Display message Available settings
Interface Parallel, Serial,
Option 1
Parallel Auto, Normal,
High Speed,
Nibble (high)
Baud Rate 1200, 2400, 4800,
9600, 19200, 38400,
57600, 115200
Data Bits 7, 8
Stop Bits 1, 2
Parity None, Odd, Even,
Ignore
Protocol DTR(positive)&XON/
XOFF,
DTR(positive),
DTR(negative),
XON/XOFF, ETX/
ACK
Barcode Mode On, Off
2-8
Remarks
"Option 1" is displayed only when
the Network Card is installed.
Displayed only when the optional
Barcode Reader is installed.