Oce OP30C Operation Manual page 76

10. Windows KX Driver
10-8 Device Settings Tab
Device Options
If any optional devices are installed, put a check mark in the checkbox for that device and perform the corresponding settings here. Once
you have completed the setting for each option, the functions of that option will be available for use.
Paper Feeder (Cassette 3 and 4)
Perform this setting according to the installed Option Cassette.
Duplex Unit
Perform this setting if your machine is a duplex copier.
Finisher
Perform this setting when the optional Finisher is installed.
In order to register the Punch Unit to be used, put a check mark in the checkbox next to "Finisher" and then double-click on the "Finisher"
name to access the "Punch Unit Settings" dialog box.
Hard Disk
Perform this setting when the optional Hard Disk is installed.
In order to register a Virtual Mailbox, put a check mark in the checkbox next to "Hard Disk" and then double-click on the "Hard Disk"
name to access the "Hard Disk Settings" dialog box.
RAM Disk
Perform this setting when you want to create a RAM disk. Refer to "5-2 RAM disk" on page 5-1 for more detailed information on creating
a RAM disk.
* In order to create a RAM disk, it is necessary to increase the memory capacity of your printer. After increasing memory, perform the
setting here according to the "Memory" setting below.
Memory
Specifies the amount of memory installed in the printer. If you make a mistake in the setting here, it is possible that printing will not be
accomplished properly.
RAM Disk
Specifies the amount of memory to be used for the RAM disk. This setting will only be available when you have selected "RAM Disk" in the
10-16