Oce OP30C Operation Manual page 70

10. Windows KX Driver
Staple
Stapling is possible if the optional finisher is installed.
* The following settings are required before stapling is possible:
(1) "Device Options" setting in the "Device Settings" Tab
• Select "RAM Disk" or "Hard Disk".
• Select "Document Finisher".
(2) "Output" Tab
• Select "Main Tray" as the "Output to" setting.
• Put a check mark in the checkbox for "Collate".
• Put a check mark in the checkbox for "Staple" and select the desired type of stapling you want performed.
Offset
This mode groups prints made from multiple originals and ejects them each one slightly shifted from the precious one.
Offsetting is possible if the optional finisher is installed.
* The following settings are required before Offsetting is possible:
(1) "Device Options" setting in the "Device Settings" Tab
• Select "Finisher".
(2) "Output" Tab
• Select "Main Tray" as the "Output to" setting.
• Put a check mark in the checkbox for "Offset".
Punch
When the optional Finisher is equipped with a Punch Unit, it is possible to have holes punched into the finished copies.
* In order to use the Hole Punch function, it is first necessary to perform the following settings.
(1) "Device Options" setting in the "Device Settings" Tab
Select "Document Finisher" and select the type of Punch Unit.
(2) In the "Output" Tab
• Select "Main Tray" or "Sub Tray" as the "Output to" setting.
• Put a check mark in the checkbox for "Punch" and select the type of hole punching you want performed.
Job Settings...
Clicking on the "Job Settings..." button opens up the "Job Settings" dialog box from which you can print out using the e-MPS (Job Storage)
function. For details, see "10-7-1 Printing using the e-MPS function" on page 10-11.
Upper Left Upper Right
10-10
Booklet