Oce OP30C Operation Manual page 45

7. Printer control commands
7-5 Reading print data
Perform the following procedure when you want to read print data that has been saved on a Memory Card or RAM Disk.
* Perform the following procedure when you want to read print data that has been saved on a Memory Card, the Hard Disk or RAM disk.
* Verify beforehand that the Memory Card is in a write-enabled state and that the RAM Disk is turned ON.
* To verify saved data and the corresponding partition name, it is helpful to print out the Partition List. Refer to "7-7 Printing out the Partition
List" for information on printing that list.
* Partition List print out can be accomplished from the operation panel on the printer itself. Refer to "2. Printer Settings" on page 2-1 for
information on the appropriate procedure.
Procedure
1 Open an MS-DOS Prompt in Windows.
2 Type in the command to read data and then press the ENTER key.
[Example] To read the print data entitled "SAMPLE.txt" from a Memory Card
* To read the data from the Hard Disk or RAM disk, simply change the "A" parameter to "0".
C:\WINDOWS>ECHO !R! RWER R,A,2,"SAMPLE.txt"; EXIT;>LPT1
3 Print out of the corresponding data will begin.
7-6 Deleting print data or font data
Perform the following procedure when you want to delete print data or font data that has been saved on a Memory Card or RAM Disk.
* Deleting data can be accomplished from the operation panel on the printer itself. Refer to "2. Printer Settings" on page 2-1 for information on
the appropriate procedure.
* Verify beforehand that the Memory Card or RAM Disk contains the data that you want to delete.
* To verify saved data and the corresponding partition name, it is helpful to print out the Partition List. Refer to "7-7 Printing out the Partition
List" for information on printing that list.
* Partition List print out can be accomplished from the operation panel on the printer itself. Refer to "2. Printer Settings" on page 2-1 for
information on the appropriate procedure.
Procedure
1 Open an MS-DOS Prompt in Windows.
2 Type in the command to delete data and then press the ENTER key.
[Example] To delete the print data entitled "SAMPLE.txt" from a Memory Card
* To delete the data from the Hard Disk or RAM disk, simply change the "A" parameter to "0".
* To delete font data, simply change the "2" parameter to "1".
C:\WINDOWS>ECHO !R! RWER D,A,2,"SAMPLE.txt"; EXIT;>LPT1
3 Deletion of the corresponding data will begin.
4 Print out the Partition List to verify whether or not the data was deleted properly.
7-3