Oce OP30C Operation Manual page 72

10. Windows KX Driver
Place a check in the checkboxes of functions you want to use.
2
Temporary ............. Data to be printed is stored on the hard disk of the printer. This can increase the speed of printing for those jobs which
involve multiple copy sets. If the area allocated for saving data becomes full when printing under the "Temporary"
setting, the data for the oldest print job will be deleted in order to make sufficient space.
Permanent ............. Data to be printed is stored on the hard disk of the printer. This can increase the speed of printing for those jobs which
involve multiple copy sets. The document data will be retained on the hard disk even if the area allocated for saving
data becomes full when printing under the "Permanent" setting. In this case, in order to save new data, use the optional
Barcode Reader or Utility Software to delete unneeded data and make space available.
* With the "Temporary" and "Permanent" settings, it is possible to use the optional Barcode Reader, or the Printer Disk
Manager and Job Manager Utility Software that are included on the enclosed CD-ROM, in order to add and delete
print jobs.
Virtual Mail Box
(VMB) .................... Data to be printed is stored in a virtual mailbox created on the printer's hard disk and can be printed out whenever
necessary using the operation panel. Up to 255 virtual mailboxes can be created. The document data will be retained
on the hard disk even if power to the printer is turned OFF, but it will be deleted once it is printed out.
Quick Copy ............ This mode allows you to use the operation panel to print out an additional number of copies for a specific print job
whenever necessary. The factory default setting for the number of print jobs that can be saved on the hard disk of the
printer is 32 (up to 50 possible under e-MPS settings). If the number of print jobs entered exceeds the available limit,
the next job will be written over the oldest data. The document data will be deleted if power to the printer is turned OFF.
Proof and Hold ...... This mode prints out only a single copy set of a multiple-copy set print job so that you can check the content and
quality of the printout first. Then, if there are no problems, you can use the e-MPS "Quick Copy" setting on the printer
operation panel to print out the required number of copy set or delete the job, as desired. The document data will be
deleted if power to the printer is turned OFF.
Private Print ........... This mode allows you to save data for a print job without printing it out. Since input of a password is required in order to
print the corresponding data, confidentiality is maintained even with shared printers. The document data will be deleted
once it is printed out or if power to the printer is turned OFF.
Job Storage ........... This mode stores data for often used formats on the printer's hard disk so that you can print out copies whenever
needed. Printing is accomplished from the operation panel on the printer after inputting a password. The document
data will be retained on the hard disk even if power to the printer is turned OFF.
If you selected "Private Print" or "Job Storage", input a password in the "Access
3
Code" field. This password can be any 4-digit number from 0000 to 9999. You will
need to input this password from the printer operation panel in order to print out.
Even if you selected "Job Storage" however, there are times when it may not be
absolutely necessary to enter the password.
10-12