Rack Model; Opening The Server - Fujitsu Siemens Computers PRIMERGY TX200 S4 Options Manual

Rack model

4.2 Rack model
Ê Exit all applications and shut down the server properly.
Ê Press the On/Off button if the server has not been switched off by the
operating system.
Ê Pull all power connectors out of the power outlets.
4.2.1

Opening the server

Pulling the server out of the rack and opening the server
Figure 3: Loosening the knurled screws
Ê Loosen the two knurled screws (1) and pull the server as far as possible out
of the rack (2).
Ê Open the latch (see also the
Ê Remove the top cover.
Removing the server from the rack and opening the server
Depending on how accessible the server is in the rack cabinet, it can make
sense to remove the server from the rack cabinet:
Ê Disconnect all cables on the rear of the server.
22
1
figure 2 on page 21).
Options Guide
Preparation
1
2
TX200 S4