Fujitsu Siemens Computers PRIMERGY TX200 S4 Options Manual page 40

Installing an accessible 5.25-inch drive
Figure 21: Removing the dummy module
Ê Push the dummy module out of the bay frontward.
V
CAUTION!
Keep the dummy module for future use. If you remove the accessible
drive again and do not replace it with a new one, the dummy module must
be reinstalled to comply with EMC regulations and to satisfy cooling
requirements and fire protection measures.
Ê Push the new drive about halfway into the bay.
Ê Connect the data cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Connect the power cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Push the drive fully into the bay and fasten it with two screws.
40 Options Guide
Accessible drives and LSP
TX200 S4