Fujitsu Siemens Computers PRIMERGY TX200 S4 Options Manual page 45

Accessible drives and LSP
Figure 28: Installing the multibay
Ê Push the multibay with its cables in the lower bay until the holes fit to the
threads.
Ê Fasten the multibay with two screws (see the circles).
Ê Connect the PS adapter cable of the slimline drive to a power plug (see the
cabling plans in the Appendix).
Ê Connect a power plug to the floppy drive (see the cabling plans in the
Appendix).
Ê Connect the floppy cable to the floppy drive and to the connector Floppy on
the system board (see the cabling plans in the Appendix).
Ê Connect the SATA cable of the slimline drive to the system board (see the
cabling plans in the Appendix).
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 85
TX200 S4
et seq..
Options Guide
Installing the multibay
45