Converting From The Floorstand Model To The Rack Model - Fujitsu Siemens Computers PRIMERGY TX150 S3 Service Supplement Manual

11 Converting from the floorstand
model to the rack model
V
CAUTION!
Observe the safety instructions in the chapter "Safety notes" on page 7
et seqq. .
Ê Open the server and remove the front cover as described in the chapter
"Preparation" on page 13ff.
I
The front cover is no longer required.
Figure 40: Removing the anti-tilt bracket
Ê If your server is equipped with an anti-tilt bracket, remove it:
Ê Remove the two knurled screws (1) and lift the server out of the anti-tilt
bracket.
U41604-Z156-1-76
Options Guide 53