Returning Camera Settings With Get Commands - Dalsa Spyder 3 GigE SG-10-01k80-00-R User Manual

Spyder 3 GigE User's Manual
Background Subtract:
System Gain (DN):
GPIO Configuration

Returning Camera Settings with Get Commands

You can also return individual camera settings by inserting a "
command that you want to query. If the command has a tap or pixel number parameter,
you must also insert the tap number or pixel number that you want to query. Refer to
T able 13 below for a list of available commands. To view a help screen listing the
3 1 9 H
following get commands, use the command
Table 13: Get Commands
Syntax
get cao
get ccf
get ccp
get css
get dgc
get dpc
get els
DALSA
0 0
4096 4096
Signal
Input0
Input1
Input2
Input3
Output0 High Impedance
Output1 High Impedance
Output2 High Impedance
Output3 High Impedance
Parameters Description
Returns the analog offset for the tap indicated
t
t = tap selection, either 1 to 2 depending on camera
model, or 0 for all taps
Returns the FPN pixel coefficients for the pixel range
x1 x2
indicated.
x1 = Pixel start number
x2 = Pixel end number
Returns the PRNU pixel coefficients for the pixel range
x1 x2
indicated.
x1 = Pixel start number
x2 = Pixel end number
Returns the number of line samples averaged for pixel
coefficient calculations or for output of
Returns the current GPIO configuration.
Returns pixel coefficients without formatting.
x1 x2
Returns whether the end-of-line statistics are turned off or
on.
0 : Off
1 : On
Background subtract
settings set with the
s sb
1 3 5 H
section
and Digital Signal
Processing Chain for
details.
Digital gain settings set
with the
See section
and Digital Signal
Processing Chain for
details.
Current GPIO pinout
Mode
configuration. Refer to
Disabled
section
Disabled
Configuring the GPIO
Disabled
Disabled Connector for details.
get"
.
gh
93
command. See
A 2.2 Analog
3 1 6 H
command.
s sg
1 3 6 H
A 2.2 Analog
3 1 7 H
A 1.5
3 1 8 H
in front of the
command.
gla
03-032-10158-09