First Power Up Camera Settings; Output Format; Sensitivity Mode; Ccd Shift Direction - Dalsa Spyder3 SG-11-01k80-00-R User Manual

34

5.3 First Power Up Camera Settings

When the camera is powered up for the first time, it operates using the following factory
settings:
•
•
•
•
•
•
•
•
•
Notes: The FPN and PRNU coefficients are factory calibrated at a 5 kHz line rate and 0dB
gain setting. While the factory setting baud rate is 9600, QuickCam sets the baud rate to
57600 at startup.

5.4 Output Format

Sensitivity Mode

Sets the camera's sensitivity mode. When using high sensitivity mode, the camera's
responsivity increases. High sensitivity mode permits much greater scanning speeds in
low light. It can also allow for reduced lighting levels.
SensitivityMode = {Low = 0, High = 1, TallPixel = 3}
•

CCD Shift Direction

When in high sensitivity mode, selects the forward or reverse CCD shift direction or
external direction control. This accommodates object direction change on a web and allows
you to mount the camera "upside down".
SensorShiftDirection = {ForwardDirection = 0, ReverseDirection = 1,
ExternalControl = 2}
•
03-032-20027-02
High sensitivity mode.
Forward CCD shift direction.
No binning.
Exposure mode 7 (Programmable line rate & max exposure time).
5000 Hz line rate.
Factory calibrated analog gain and offset.
enabled (1k and 2k use). (It is recommended that you use the
Analog gain
command with the 4k in order to maintain valid LUT calibration.)
gain
LUTs enabled (4k default), factory calibrated @ -10dB.
Factory calibrated FPN and PRNU coefficients using the following process: line rate
of 5000 Hz, analog gain calibrated to an average pixel value of 248 DN, fpn
calibration, prnu calibration, 8 bit output, 9600 baud rate, exposure mode 2.
The SensorShiftDirection command is not available in low sensitivity mode or tall
pixel mode.
Available in high sensitivity mode only.
Spyder3 GigE Vision User Manual
system
DALSA