A5 Error Handling - Dalsa Spyder 3 GigE SG-10-01k80-00-R User Manual

104

A5 Error Handling

The following table lists warning and error messages and provides a description and
possible cause. Warning messages are returned when the camera cannot meet the full
value of the request; error messages are returned when the camera is unable to complete
the request.
Table 15: Warning and Error Messages
Message
OK>
Warning 01: Outside
of specification>
Warning 02: Clipped
to min>
Warning 03: Clipped
to max>
Warning 04: Related
parameters
adjusted>
Warning 05: Can't
set LVDS for this
GPIO signal
Warning 07:
Coefficient may be
inaccurate A/D
clipping has
occurred>
Warning 08: Greater
than 1% of
coefficients have
been clipped>
Warning 09: Internal
line rate inconsistent
with readout time>
Message
Error 02:
Unrecognized
command>
Error 03: Incorrect
number of
parameters>
Error 04: Incorrect
parameter value>
Error 05: Command
unavailable in this
mode>
03-032-10158-09
Description
SUCCESS
Parameter accepted was outside of specified operating range (e.g. gain
greater than ±10 dB of factory setting).
Parameter was clipped to the current operating range. Use gcp to see
value used.
Parameter was clipped to the current operating range. Use gcp to see
value used.
Parameter was clipped to the current operating range. Use gcp to see
value used.
Input 3 and Output 3 cannot be set to use an LVDS signal.
In the region of interest (ROI) greater than 6.251% single or 1% of
averaged pixel values were zero or saturated.
A FPN/PRNU has been calculated to be greater than the maximum
allowable 511 (8).
Description
Command is not available in the current access level or it is not a valid
command.
This response returned for
· Alpha received for numeric or vice versa
· Not an element of the set of possible values. E.g., Baud Rate
· Outside the range limit
Command is valid at this level of access, but not effective. Eg line rate
when in smart EXSYNC mode
Spyder 3 GigE User Manual
DALSA