A3 Saving And Restoring Settings - Dalsa Spyder 3 GigE SG-10-01k80-00-R User Manual

Spyder 3 GigE User's Manual

A3 Saving and Restoring Settings

For each camera operating mode (high sensitivity forward direction, high sensitivity
reverse direction, low sensitivity, or tall pixel), the camera has distinct factory settings,
current settings, and user settings. In addition, there is one set of factory pre-calibrated
pixel coefficients and up to four sets of user created pixel coefficients for each operating
mode.
Figure 25: Saving and Restoring Overview
Factory Settings
On first initialization, the camera operates using the factory settings. You can restore the
original factory settings at any time using the command
User Settings
You can save or restore your user settings to non-volatile memory using the following
commands. Pixel coefficients are stored separately from other data.
Current Session Settings
These are the current operating settings of your camera. To save these settings to non-
volatile memory, use the command
DALSA
For each camera operating mode:
Low Sensitivity
High Sensitivity Forward
High Sensitivity Reverse
Tall Pixel
User
Settings
rus lpc ,
Current
Session wus wpc,wfc
,
4 sets of user
pixel coefficients
•
To save all current user settings to EEPROM, use the command
will automatically restore the saved user settings when powered up.
settings are being written to nonvolatile memory, do not power down camera or
camera memory may be corrupted.
•
To restore the last saved user settings, use the command
•
To save the current pixel coefficients, use the command
•
To restore the last saved pixel coefficients, use the command
Factory
Settings
1 set of factory
pixel coefficients
rfs
.
wus
.
. The camera
wus
Note:
While
.
rus
and wfc.
wpc
.
lpc
03-032-10158-09
83