First Power Up Camera Settings - Dalsa 4M30 User Manual

22
gpc get prnu coefficient
gsf get signal frequency
h
lpc load pixel coefficient
rc reset camera
rfs restore factory settings
rpc reset pixel coefficients
rus restore user settings
sao set analog offset
sbr set baud rate
sdo set digital offset
sem set exposure mode
set set exposure time
sfc set fpn coefficient
snd set number frame dumps
sot set output throughput
spc set prnu coefficient
ssb set subtract background
ssf set sync frequency
ssg set system gain
svm set video mode
vt verify temperature
vv verify voltages
wfc write fpn coefficients
wpc write prnu coefficients
wse window start end
wss window set sequence
wts window trigger source
wus write user settings
OK>
Retrieving Camera Settings
To retrieve current camera settings, use the command:
Syntax:

3.1 First Power Up Camera Settings

When the camera is powered up for the first time, it operates using the following factory
settings:
PT-41-04M60
03-032-20044-01
help
gcp
•
Flat field coefficients enabled (calibrated in exposure mode 2, 55 fps, and an
exposure time of 2 ms [non-concurrent readout and integration], snapshot mode
1, number of fast frame dumps = 1)
•
Exposure mode 2
•
60 fps
xy 1-2352:1-1728
m 1/4/
ti 0-0:0-511
m 9600/19200/57600/115200/
ti 0-2:0-2048
m 2/3/4/6/7/
f 492-999989 [us]
xyi 1-2352:1-1728:0-1023
i 1-7
m 260/320/
xyi 1-2352:1-1728:0-12287
ti 0-2:0-511
f 1.0-60.4 [Hz]
ti 0-2:0-65535
i 0-12
iixyxy 0-0:1-1:1-1:1-1725:2352-2352:4-1728
i 0-1
m 1/2/
Falcon 4M Camera Manual
DALSA