Camera Frequency Measurement; Returning The Led Status; Returning Camera Settings - Dalsa PC-30-02K80-R Manual

Piranha Color Camera User's Manual
10%). The measurement should not be used to set the applied voltage to the camera but
only used as a test to isolate gross problems with the supply voltage.

Camera Frequency Measurement

Purpose:
Syntax:
Syntax Elements:
Note:
Example:

Returning the LED Status

Purpose:
Syntax:
Notes:

Returning Camera Settings

Returning All Camera Settings with the Camera Parameter Screen
The camera parameter (gcp) screen returns all of the camera's current settings. The table
below lists all of the gcp screen settings.
To read all current camera settings, use the command:
Syntax:
gcp
DALSA
Returns the frequency for the requested Camera Link control
signal
gsf i
i
Camera Link control signal to measure:
1: CC1 (EXSYNC/Blue PR)
2: CC2 (Green PR)
3: CC3 (CCD Direction)
4: CC4 (Spare/Red PR)
Accuracy: ±271 ns
Reliable up to 40,000 H
gsf 1
Returns the status of the camera's LED.
gsl
The camera returns one of the following values:
2 = green (camera is operating correctly)
5 = flashing green (camera is performing a function)
6 = flashing red (fatal error)
Refer to section 2.3 Camera LED for more information on the
camera LED.
03-032-10211-03
64
9/27/2007