A4.3 Temperature Measurement; A4.4 Voltage Measurement - Dalsa Spyder 3 GigE SG-10-01k80-00-R User Manual

88
Returning the Average of Multiple Lines of Video
Purpose:
Syntax:
Syntax Elements:
Notes:
Related Commands:
Example:

A4.3 Temperature Measurement

The temperature of the camera can be determined by using the
command will return the internal chip case temperature in degrees Celsius. For proper
operation, this value should not exceed 75°C.
Note:
this occurs, the camera must be rebooted using the command,
down manually. You will not be able to restart the camera until the temperature is less
than 65°C. You will have to correct the temperature problem or the camera will shutdown
again. The camera allows you to send the
this state.

A4.4 Voltage Measurement

The command
measurement feature of the camera provides only approximate results (typically within
10%). The measurement should not be used to set the applied voltage to the camera but
only used as a test to isolate gross problems with the supply voltage.
03-032-10158-09
Returns the average for multiple lines of video data (without pixel
coefficients applied). The number of lines to sample is set and
adjusted by the css command. The camera displays the Min.,
Max., and Mean statistics for the pixels in the region of interest (the
region of interest command is explained in section
Region of Interest (ROI)).
gla x1 x2
x1
Pixel start number. Must be less than the column end number
in a range from 1 to sensor resolution .
x2
Pixel end number. Must be greater than the column start
number in a range from 2 to column resolution.
•
If x2
•
Analog gain, analog offset, digital offset, background subtract,
and digital system gain are applied to the data. FPN and
PRNU coefficients are not included in the data.
•
Values returned are in 12 bit DN.
,
c ss r oi
1 1 7 H 1 1 8 H
gla 10 20
If the camera reaches 75°C, the camera will shutdown and the LED will flash red. If
displays the camera's input voltage. Note that the voltage
vv
≤
x1 then x2 is forced to be x1 .
(verify temperature) command while it is in
vt
Spyder 3 GigE User Manual
A 2.1 Setting a
2 9 4 H
command. This
vt
or can be powered
rc
DALSA