Power Connector; Gpio Connector - Dalsa Spyder 3 GigE SG-10-01k80-00-R User Manual

26

2.4.2 Power Connector

Figure 9: Hirose 6-pin Circular Male—Power Connector
Hirose 6-pin Circular Male
The camera requires a single voltage input (+12 to +15V). The camera meets all
performance specifications using standard switching power supplies, although well-
regulated linear supplies provide optimum performance.
!
WARNING: When setting up the camera's power supplies follow these guidelines:
•
•
•
•
•
Note: Camera performance specifications are not guaranteed if your power supply does not meet
these requirements.
DALSA offers a power supply with attached 6' power cable that meets the Spyder 3 GigE
camera's requirements, but it should not be considered the only choice. Many high
quality supplies are available from other vendors. Visit the
list of companies that make power supplies that meet the camera's requirements. The
companies listed should not be considered the only choices.

2.4.3 GPIO Connector

The GPIO connector is used to receive or control external signals. For example, the GPIO
connector can be used to receive EXSYNC, PRIN (pixel reset), and direction signals.
Figure 10: GPIO Connector and Pin Numbers
Table 5: GPIO Connector Pinout
Pin
1
03-032-10158-09
1 6
5
2
4
3
Mat ing Par t: HIRO SE
HR10A -7P-6S
Apply the appropriate voltages
Protect the camera with a
Do not use the shield on a multi-conductor cable for ground.
Keep leads as short as possible to reduce voltage drop.
linear
Use high-quality supplies to minimize noise.
1
5
11
15
Signal Description
INPUT_ 0+ LVDS/TTL format (positive)
Table 4: Hirose Pin Description
Pin Description
1 Min +12 to Max +15V
2 Min +12 to Max +15V
3 Min +12 to Max +15V
fast-blow fuse
between power supply and camera.
Spyder 3 GigE User Manual
Pin Description
4 GND
5 GND
6 GND
w ww.dalsa.com Web site for a
1 1 H
DALSA